Boldenon 200 / Boldenone Cypionate 200mg/ml for Bodybuilding

Boldenone Cypionate 200mg/ml

Boldenone Cypionate raw powders
Solvents(Pharmaceutical Grade): benzyl alcohol & benzyl benzoate
Carrier: USP Grape Seed Oil

 

Applications:
 
Boldenone will increase nitrogen retention, protein synthesis, increases appetite and stimulates the release of erythropoietin in the kidneys.

Boldenone was synthesized in an attempt to create a long-acting injectable methandrostenolone (Dianabol),for androgen deficiency disorders. Boldenone acts similar to methandrostenolone with less adverse androgenic effects. It has a very long half-life, and can show up on a steroid test for up to 5 months, due to the long undecylenate ester attached to the parent steroid. Trace amounts of the drug can easily be detected for months after discontinued use.

Boldenone is an anabolic androgenic steroid and synthetic derivative of testosterone that was originally developed for veterinary use ,it ideal for the strength athlete in a shorter cycle.

 

A cycle example:
 

steroids cycle

 

How to inject

If you are going to start your first cycle soon, ‘how to inject’ is probably that last thing that you are worried about. You would have started by conducting research on the different injectable anabolic steroids available in the market, which you think can help you reach your goal. But when you have the vials and the syringes in front of you, you will surely think about how you will get the steroid out from the bottle and into your body. At this point, some people will become exasperated and even give up. Here is some information on injecting anabolic steroids.

Draw some air into the syringe and inject it into the vial. The pressure in the vial will increase and drawing the liquid into the vial will become easier. Make sure that the tip of the pin is under the liquid and then pull the plunger back slowly, to draw the volume of liquid that you desire.

If you want, you can change the needle after this. The needle may have lost some of its sharpness as it made its way through the stopper and may cause some discomfort when you prick your skin with it.
Clean the area, which you are going to inject into, with a fresh alcohol swab. Place the pin over the area and simply push it fully. Draw the plunger back a little. If you notice any blood inside the syringe, you have probably hit a vein or an artery and you need to choose another spot. Repeat the same procedure again.

After a few seconds, remove the pin and immediately cover the injection area with a fresh cotton ball and press for a few seconds. If you see a little blood, it is okay. You just pierced the skin and some blood is bound to come out.

Leave a Reply

Fill in your details below or click an icon to log in:

WordPress.com Logo

You are commenting using your WordPress.com account. Log Out /  Change )

Google+ photo

You are commenting using your Google+ account. Log Out /  Change )

Twitter picture

You are commenting using your Twitter account. Log Out /  Change )

Facebook photo

You are commenting using your Facebook account. Log Out /  Change )

Connecting to %s